SD3 and reverb

[greg54]

In SD3 I have turned off all the reverb in the OH, AMB channels, and still there is a lot of reverb, especially with the snare.   I can get most of it out, but when I close a project and then go back into it, the reverb is back.   But when I get most of it out, the snare does not sound natural.

Any suggestions how to get rid of reverb for good?

Topic

[Scott Eshleman]

are you sure that what you’re hearing isn’t bleed of snare in other microphones?

1

Thanked by: greg54

[Henrik]

Scott Eshleman wrote:

are you sure that what you’re hearing isn’t bleed of snare in other microphones?

Solo the Snare Top, and/or Snare Bottom channels in the mixer to rule out any other sources for the reverb sound.

Henrik Ekblom - User Experience Designer
Toontrack

1

Thanked by: greg54

[greg54]

Scott, Henrik – I thought I had gone through everything in the mixer.  But I noticed the knobs at the very top.   I opened it, and it was about mic bleed.  I turned the knobs off on all the channels, and that helped a lot.

Thanks!

Greg

• This post was modified 4 years, 11 months ago by greg54.

[Author]

Replies