What could be causing the input from my module to be so low? I have to raise the SD2 velocity curve way too much for all drums; so much that it adversely effects the dynamics. With velocity at default in S2, striking the pads barely registers velocity to halfway on the LEDs.
Trigger sensitivity is set correctly so that harder hits register up to 127 (in the module, not in S2).
** I have this same problem running EZ2 also.
The way I’m setup is
TD30 to PC via USB
ASIO4all driver installed
midi device set to TD30
audio device set to ASIO
Midi mapping to e-drums (roland)
