[midilance]

I think it’s aftertouch.  I must have pressed too hard.  In DP I went into View filters and had it show only Mono Pressure and found out that it was on the midi note.  I deleted it and the crash fully plays.  Voila!  Thanks man.

2

Thanked by: drumjack52 and Brad

[midilance]

OK.  I’m a newbie so I apologize for being clueless.  So in SD the panning is like in the picture, right?   By the way, I’m liking SD so far.  I was with BFD for a long time.

Reply To: In a current project, moved from BFD to SPD cymbals don’t show up on mixer version: 3.4.2
Operating system: macOS Tahoe (26)

[midilance]

So there aren’t supposed to be separate mixer track for cymbals.  I can’t change the panning on them?

Reply To: In a current project, moved from BFD to SPD cymbals don’t show up on mixer version: 3.4.2
Operating system: macOS Tahoe (26)

[midilance]

I see the cymbals in the picture of the drumset.  I don’t see corresponding channels in the mixer.  I don’t understand.

Reply To: In a current project, moved from BFD to SPD cymbals don’t show up on mixer version: 3.4.2
Operating system: macOS Sequoia (15)

[midilance]

I just figured it out.  My bad.  Levels, levels, levels.  Whew!

Reply To: Newbie question version: 3.4.2
Operating system: macOS Tahoe (26)

[midilance]

My velocities are the same that I used with BFD3.5.  I’m a longtime user of BFD3.  An open SD3 near the top right shows Level  0.0. I haven’t been able to find where to “up” my output.  It’s really low.

Reply To: Newbie question version: 3.4.2
Operating system: macOS Tahoe (26)

[Author]

Replies