[Mark Frank Ratnam]

Thanks all for your replies. Will try out the various options.

However, maybe I should clarify that I am running my drums in a live/recording studio setup with other live instruments. And that’s why I wanted the drums as two separate channels in my DL16s Mackie mixer. This will allow each instrument (drums, guitar, etc)  to be controlled using the AUX channels as in-ears monitoring for live/silent jamming.

I used to run the EZD3 directly from the Mac to DL16 using the Return Channels but that affected my ability to have separate audio track channels from the drums. It was rather limiting.

And if I were to run all the instruments through Logic from the DL16 to the MAC, I can have separate channels for the drums and instruments all controlled in Logic… with full controls to compressor and gate etc… but that would not allow individual musicians to control the mix for their in-ears.

Trying to figure out a proper workflow to get the best of everything here.

Sorry if I seem to be asking too much… just trying to figure out options which will work best here.

Reply To: Compressor/gate in ezd3 version: 3.1.0
Operating system: macOS Sequoia (15)

[Mark Frank Ratnam]

Thanks so much for your reply. I’ve managed to change the midi note of one of the rack toms through the DTX module cuz it seems easier to change in the DTX compared to the TD11.

Reply To: Setting different MIDI presets for 2 different modules in EZD3 version: 3.0.6
Operating system: macOS Sequoia (15)

[Author]

Replies