[john krummrich]

Thanks for the reply.

I have a large and complex setup. I have over 100 inputs in hardware. Behringer wing, x32 rack and 2 soundgrid servers.

I like to record my e drum parts to SD3. midi editing of drum parts is so much faster for SD3 parts in SD3. Mainly  because all the articulations show up on the grid. And change with every kit almost.  I can get multiple outs if I run it inside of Nuendo but that is multiple outs within Nuendo. And it takes a lot of workarounds to get individual outs to my mix setup.at least as far as I know, For now I take the edited MIDI from SD3 put it it Nuendo and send it to SD3 over rtpMIDI.

I have 7 different computers running and like to use SD3 as a kind of tape meschine. 2 Nuendo setups. Dolby Atmos renderer, Wwise, unreal engine and Davinci resolve. I have dedicated systems for all. I send MTC and time code all over the place and  just wish SD3 would take it in stand alone. Hope this makes  some kind of since. It does show I am crazy.

Reply To: MTC in on stand alone version: 3.3.5
Operating system: Windows 11

• This post was modified 2 years, 10 months ago by john krummrich.

[Author]

Replies