GADeuvall2000
Participant
Topics Started: 4
Replies Created: 6
Has Thanked: 0
Been Thanked: 0
GADeuvall2000I’m not seeing a button labeled more, so maybe it’s not a button, and I don’t use the physical photo of the drums to select my instruments, but rather the dropdown list to do so, since it reads names. Anyways, I’m still trying to figure something out for now. Thanks.
BTW, where could the more button be found close to?
Also, is there a midi learn function for drum pads? I thought there was.
GADeuvall2000Okay how do I do the routing of mics? This may not be possible with my screen reader currently, but soon, we will hopefully have a SIBIAC overlay for this, but currently I”m ust using OCR to explore and evaluate stuff.
What general area would it be in and any text nearby This is how I have been learning this software thus far.
GADeuvall2000OKay..
* I do have all parts of SD3 installed
* I tested both standalone and within a DAW (Reaper)
* I do have the latest update installed
Let me make sure I am a bit clearer on what is happening, because after reading my own post it does sound a bit offset from what it meant.
I will load the Andy Sneed 2 Preset and everything plays once all the sounds are loaded.
I can add additional kit pieces from different expansion libraries and they play just fine. EG: I add the bell from the Drums of Destruction EZX as an additional instrument, and it loads and plays just fine.
I can swap kick, snare or toms on the Andy Sneed preset and they play just fine.
I can load any other preset in SD3, and swapping out cymbals works fine for me. I just tried with several different other presets with no
issues with any of them.
If I don’t load any preset and change out kit pieces, it plays just fine.
IT just seems to be affecting me with the Andy Sneed presets thus far. if I load them, they work fine with default cymbals, however, changing out cymbals causes sound to go silent.
Being blind I cannot check the mixer, but common sense would tell me that if any cymbal is being replace, especially since it’s working everywhere else thus far, it shouldn’t be an issue here. If I am missing something, I apologize for being a bother, but I just don’t understand what is going on here.
GADeuvall2000Hmm, it doesn’t seem to do this whenever adding the additional cymbal as, say, a additional instrument. but why would it silence the sound of a cymbal from it’s own expansion? that’s the part that puzzles me. like, absolutely no sound plays on cymbal 1 when he preset is loaded, except the cymbal that is default to the kit piece, or at least that’s how it’s looking.
GADeuvall2000Hey guys, I have a question to ask in regards to updating a computer with new hardware.
On my desktop, I installed all my products that I had at the time, then I upgraded the HDD and with that did a complete fresh install of Windows plus my Toontrack software. and had to reactivate everything.
Additionally, I purchased a laptop and installed my products and activated them on it, however, it wasn’t strong enough, so I ended up selling it after uninstalling and formatting the HDD. I deactivated everything on the TT website. I purchased a new laptop and installed my products on it, but am about to upgrade the HDD on it which means I will most likely be doing a fresh install of Windows on it and reinstalling my software.
Does installing to the same computer with a new HDD count towards one of the four activations? If so, can I reset these? leaving my current in tact?
GADeuvall2000Okay, just let me know what I need to do on my end in regards to this, for I am left a little confused with your statement about setting me up via email.
No products in the cart.