Using EZdrummer2 with Samplitude?

[millardfarmer]

Any advice on installing the EZdrummer into Samplitude Music Studio 2013 would be greatly appreciated. I have followed the instruction of adding the correct plugin path ( C:Program FilesVstPluginsToontrackEZdrummer.dll) to the “VST Plugins” at “Effects/DirectX/ReWire” setup window. I have the “Activate ReWire” checked. I have clicked on the ‘folder’ and from the drop-down menu clicked on the “(Re-) Scan selected folder”, as well as the (Re-) Scan selected folder including failed plugins”. EZDrummer does not appear in my VST instruments and I am at a loss of what else to do as the above is following the instructions offered by Samplitude and Toontrack.

Topic

[Scott]

Music Studio isn’t a supported DAW for Toontrack samplers. The full version of Samplitude is though.

Scott Sibley - Toontrack
Technical Advisor

[Andreas Kersten]

EZdrummer (1 & 2) works fine with Samplitude Music Studio 2013 (and newer). Checking “Activate ReWire” is not needed. I bet you just pointed to the wrong .dll/folder. Samplitude Music Studio 2013 is 32bit only, so check the path again to point to the correct .dll. I personally prefer my VST’s installed to C:VST (32bit) and C:VST64 (64bit) which helps to keep everything clean and easy.

[macca_1]

I have the same problem with samplitude 11 pro cant see the vst anywhere did you sort out the problem do I have to upgrade to a newer version of sam

[MSTR79]

Anyone already knows a solution? I have the same problem.

[MSTR79]

My solution to the problem was:
I renamed the Plugin Folder. Usually my plugins were in C:/VST Plugins and I renamed it to “C:/VSTPlugins” (no space).
I rescanned the folder via Samplitude, then it finally found the EZdrummer.dll and I can now use the software in Samplitude 🙂

[Author]

Replies