Stereo to Mono

[Hataru]

Using Ezd3 I hear sounds very low when I move on toms from left to right. I immagine it could be because Exd3 works on Stereo and my mixer works only Mono. How could I set up Ezd3 to works mono?

EZdrummer version: 3.0.6
Operating system: macOS Sequoia (15)

Topic

[Mick Avoidant]

Can you tell us anything more? What are you hearing? Which room, drum kit and preset are you working in? Are you working in an expansion pack?

 

You can pan drums to the middle in Mixer tab, but not set anything to mono.

[Hataru]

Hi, I should return to my RolandTd12 on Friday and give you all details.

I can describe my setup. RoladTD12 send midi to ezd3 on my Mac. then send back with USBcable to Roland SPSDXPRO and it send to mixer the results.

I receive in my headphone from mixer. Mixer is Behringer xr16. All cable are from MONO line (sometimes are stereo but if u use only one it send MONO).

I don’t know if I miss something after EZD3 with stereo/mono setup.

Expansion Pack is Rock! Basic Preset

[MauricioLuque]

• MIDI cable is stereo
• Roland TD12 works in stereo
• USB cable is stereo
• headphones (at least the all I know) are stereo
• Behringer XR16 works in stereo

Do yo have inserted the audio cable in the right output in the TD12 module? (is the one labeled “L(MONO)”

 

 

Mauricio Luque
My self-band and discography: Mauricio y Los Vicios

[Bear-Faced Cow]

Best to use an audio interface with monitor output with your Mac and not the drum module to start. From there, you should be able to plug the outputs from your monitor output the inputs of your mixer and your volume should be fine. Plenty of budget freiendly interfaces. When I am using a portable interface, rather than my studio one, I use either a UA Volt 276 or Lewitt Connect (I have a Connect 6, but the Connect 2 should do you well).

jord

---

Jordan L. Chilcott

Web Site: https://jordanchilcottmusic.com/

[Author]

Replies