No products in the cart.
Can I have two stereo outs? …say, Out 1/2 AND Out 3/4…that way I can process them independently? I’ve seen people do separate busses, but wouldn’t they still end up being processed by whatever you had on your Out 1/2?
Can I route the entire output to another channel? Like a multi-channel, but not sending individual tracks/drums to separate channels…instead, just send the entire mix to another channel for parallel processing?
Maybe there’s another/easier way…any advice on this topic would be most appreciated.
Yes, you can use separate outputs and process them independently. Anything routed to your other outputs will not be affected by what’s on one and two. Any type of bus processing from that point would have to be done within your DAW.
jord
1
Thanked by: WarBeerDo I have to use the “bus sends” and then send that to another output? Because I can’t seem to be able to select more than one pair of outs at a time.
Yes, in SD3 you would have to use a bus send if you want to go to both channels simultaneously.
jord
No products in the cart.