Are you using a preset or have you customised one?
By right-clicking an Instrument, you can go to ‘More>Route Instrument Microphones…’ and assign the sampled microphones to channels in the mixer or create a new channel.
If you add Instruments from your own samples or other libraries than the current main library, you should check the Microphone assignments first.
In the mixer, you can Edit Visibility to Show All Channels, if you want to see the unused ones to turn on Bleed in them.
I think I figured it out. I was using Sup Dmr 3 >Bob Rock, >Rock kit 1. And you couldn’t hear the cymbals. When you opened the mixer the OH and AMB mics said” no mics routed”. So I couldn’t figure out how to route them at first. But then I “Cleared” them and reset each cymbal. And it seems to work now. Just not sure why it opened liked that.
Wondering if you installed the surround channels, since the Rock kit 1 preset uses the Front Height and Rear Height channels (which contain cymbals) as well as the OH Cond specifically for cymbal routing.
