How to tweak ED3 to live playing?

[Niels Peter Kjeldsen]

Hi,

I just installed EZDrummer 3 on a Windows 10 laptop.

Playing at home with earphones and Roland TD-11 sounds ok.

Playing in rehearsel studio on Roland TD-11 over PA, the balance between intruments is bad. Two rack toms sounds identical in volume, but floor tom is way lower.

How can I balance the individual instruments?

Perhaps there is a guide somewhere?

Regards,

Niels

EZdrummer version: 3.0.6
Operating system: Windows 10

Topic

[Mick Avoidant]

There is a volume control near the top left of the EZD window. Click on the drum you want to tweak.

1

Thanked by: Niels Peter Kjeldsen

[Shootie]

I’m not sure which preset you’re using. Assuming you’re performing even dynamics, that floor tom is pretty loud. A lot of it’s volume comes from low end frequencies. If you’re PA doesn’t reproduce low end well, that could be the issue.

And to echo Mick, on the Drums Tab, you can adjust individual volumes if the mixer tab does not have individual tom controls. Your drum mix might sound off when bringing it to a different PA or venue though. So be ready to re-adjust.

EZD3 Tutorials | EZBass Tutorials | Toontrack themed FB Group | Toontrack themed Discord Group

1

Thanked by: Niels Peter Kjeldsen

[Martin Weterholt]

also; it might be that your monitor is mono, while the sounds that are being produced are in stereo. Had that same problem on mij DB monitor too,

EZdrummer version: 3.0.6
Operating system: Windows 11

[Author]

Replies