EZD3 Parameters

[sync00]

I’m using EZD3 in Gig Performer. I set up a knob in GP to control the output volume of EZD3. There are 100 numbered parameters in EZD3 that I can control and I can’t find any documentation on what the parameters do.

EZdrummer version: 3.0.4
Operating system: Windows 10

Topic

[John]

Hi,

the output volume of the plug-in would best be controlled by CC7 Volume. The parameters are tied to macros for e.g. bleed in different channels or amount of a certain effect. The first parameters will always control the knobs under the mixer on the Mixer page.

BR,
John

John Rammelt - Toontrack
Technical Advisor

1

Thanked by: sync00

[dhjdhj]

I just tried EZdrummer 3 with Gig Performer and I found that I could only learn the dials below the mixer. I’m not quite sure why there are 100 Params.

However, after a little experimentation, I did find that I could manually associate  CC numbers with sliders in the mixer and then by mapping widgets to the appropriate MIDI CC parameters the sliders could be controlled by widgets (and then of course you can leverage GP’s scaling curves etc)

Unfortunately, host automation for those MIDI parameters doesn’t seem to be fully implemented since moving a slider is not triggering host automation so you can’t have Gig Performer learn the MIDI parameter. Consequently, all the mappings need to be set up manually.

 

D

(Gig Performer support)

[Author]

Replies