EZD2 Solo and NanoKontrol

[David Young]

i would like to get the transport controls in EZD2 to work with my NanoKontrol’s TC Buttons. I’ve gone into the Kontrol Editor Software and changed these to MMC/127, but no luck. Interestingly, the buttons on the nanokontrol that are for typical Solo/Mute, will map to the TC buttons in EZD2 through midi learn, but the TC buttons on the nano will not. The aforementioned solo/mute buttons, are listed as CCs on the kontrol editor….so I changed the TCs BACK from MMC to CC….and nothing still. Does EZD2 use MMCs?
Anyone have any ideas?
Thanks

Topic

[Olof Westman]

>Does EZD2 use MMCs?

No. Sysex messages are filtered off pretty early on. Only
CC can be ‘MIDI learned’. That’s the way to go.

Sending MIDI Start(0xFA), MIDI Continue(0xFB) or MIDI Stop(0xFC)
may have some effect but that is largely untested.

Olof Westman - Toontrack
Coder

[Author]

Replies