EZbass via vst in mixcraft studio plays notes every now and then!

[Ketil Ervik]

I tested EZdrummer via vst in mixcraft and it works...

I tested EZdrummer via vst in mixcraft and it works very well on midi files. But when I try the same with EZbass via vst the bass becomes strangely low in octaves and plays choppy notes every now and then! Why does it do that? What can i do about it?

EZdrummer version: 14
Operating system: Windows 10

Ketil Ervik

I tested EZdrummer via vst in mixcraft and it works very well on midi files. But when I try the same with EZbass via vst the bass becomes strangely low in octaves and plays choppy notes every now and then! Why does it do that? What can i do about it?

EZdrummer version: 14
Operating system: Windows 10

Ketil Ervik

Topic

[Mick Avoidant]

Ketil Ervik wrote:

I se that.

Can i use this for vst in reaper? https://www.toontrack.com/product/country-ezkeys-midi/

That’s a MIDI pack and needs ezkeys.

[Ketil Ervik]

I have ezkeys.

I bought all four products from you a few years ago.

ketilervik@yandex.com

Ketil Ervik

• The post has been modified 4 times, last modified 8 months, 2 weeks ago by Ketil Ervik.

[Ketil Ervik]

No, unfortunately I was wrong. The fact that it turned out right was enough for me to use a different midi file.

Well, today I have the same bass problem in Reaper that I had yesterday in Mixcraft.

But I finally found the cause and solution to the problem. Something you should keep in mind if others run into the same problem!

I found this link: https://www.reddit.com/r/Reaper/comments/gl2fze/some_midi_notes_wont_playback/

The solution is as follows;
I loaded a midi file into a midi file editor, in my case MidiYodi and set the bass an octave up, but left the other tracks unchanged. I saved the file and louded it into Reaper. Then I changed the sound on the bass channel to EZbass and started the midi file. And yes, now the bass sound played correctly throughout the entire melody. Just to be safe, I tested several midi files that way, and no problem.

Ketil Ervik

[Mick Avoidant]

Looking back, I had a bass vst that needed a higher octave than others.

[Ketil Ervik]

EZbass vst plugin need it every time.

 

I have also now solved the problem that there was no sound from the Korg M1 vst plugin when I, for example, changed the sound on the piano channel to the korg m1 vst plugin. I went into the Global midi channel menu. There the midi channel was set to 1. When I set it to 3 the sound came and Mixcraft could register it. I can now select all the sounds on the korg m1 vst plugin and use them on the channel in mixcraft studio. Hurray.

Ketil Ervik

[Mick Avoidant]

Well done on working it out

[Ketil Ervik]

Thanks. And thanks for all info and help.

Ketil Ervik

[Author]

Replies