1. Forums
  2. EZdrummer Line
  3. EZdrummer Help
  4. Positional Awareness with EZD3?

Positional Awareness with EZD3?

EZdrummer Help
Viewing 5 replies - 1 through 5 (of 5 total)
  • Replied November 26, 2024 at 20:04 #3324707
    Mick Avoidant
    Participant

    Some drums have a bigger difference between center and edge than others. Try Jeff Ocheltree Carbon Steel in Bright Room.

    1

    Thanked by: 12manyhobbies
    Replied November 26, 2024 at 20:58 #3324767
    Shootie
    Participant

    On the Grid Editor near the bottom where it says Velocity. Click there to expand the midi values editor. If you see a CC# assigned to snare, then you have the positioning attribute.  Older EZXs for the most part will not have it.

    The data written here while you record your edrums is what changes your articulation.

    I’m not big into this stuff, so my terms may be off.

    EZD3 Tutorials | EZBass Tutorials | Toontrack themed FB Group | Toontrack themed Discord Group

    Replied November 26, 2024 at 21:06 #3324777
    Bear-Faced Cow
    Participant

    If you are using an older EZX then you may not have zone control as earlier versions or EZ Drummer probably didn’t support zone control, so there was no mappings. Newer EZXs will have the zone control.

    Jord

    Jordan L. Chilcott

    Web Site: https://jordanchilcottmusic.com/

    Replied November 26, 2024 at 21:37 #3324820
    12manyhobbies
    Participant

    Thank you!  I do see the CC info, so that makes sense.

    Replied November 26, 2024 at 21:38 #3324821
    12manyhobbies
    Participant

    Very helpful.  Thank you for the response!

  • Author
    Replies
Viewing 5 replies - 1 through 5 (of 5 total)

No products in the cart.

×
menu
Play / pause
0:00
0:00
    volume
    ×