Hello,
Just wondering if anyone may know about this and if there is anything done to resolve it. Here is what I sent support:
I have a strange issue with the VH-10 hi ht CC and The Rock Warehouse SDX. I guess it’s weird because it doesn’t do it in the Core library. When I close the HiHat tight the core library registers the CC properly, but the Rock Warehouse seems to treat one of the higher values as a “2”. To make sure it wasn’t the VH-10 I tried the core library, and it was fine. To take it a step further, I set up a MIDI monitoring tool and put it side by side to the Superior Drummer MIDI message tool running at the same time and ONLY closed and opened the hi-hat controller. The images will be explanatory. File names are the library used. Left side of pictures is the 3rd party MIDI monitor tool and right side is SD3’s MIDI monitor.
Support responded:
“Mapping presets can help transform incoming MIDI into new MIDI notes that SD3 will use for its layout. Are you using a MIDI mapping layout right now? The active preset, if available, can be found in the MIDI-in/E-drums area.”
I responded:
I have the TD17 module local turned off and have the driver setting set to “Vendor” as suggested when using SD3. I have the MIDI-in/E-Drums settings set to use the Roland TD17 module. This seems to only happen when I load the Rock Warehouse SDX. Just to give you a little more info. If I press the HiHat to a really tight position it actually plays the Open Hat. If I start to open the HiHat just enough to lower the MIDI message to 120ish and below it will start to play the closed sound. Hope this makes sense.
No response from support yet.
I have also attached the images I sent them.
Just posting it here to see what others have to say.
Thanks!
Superior Drummer 3 version: 3.3.6Operating system: Windows 10
