Topic: Audio Sender and Logic Pro X

Viewing 3 replies - 1 through 3 (of 3 total)

Replied October 8, 2020 at 13:29 #2629414

Stefan Branberg
Participant

Hi! Do you have “Input Monitoring” turned on on the channel that you have Audio Sender on? If not, the audio will never reach the Audio Sender plugin and it will not have anything to send to EZBass.

I will also add that if you have any input latency it’s better to first record audio to a track and then send the recorded audio to EZBass with the Audio Sender. This is because the DAWs usually have some input latency compensation that they apply after the recording is finished, and that’s something that the Audio Sender can’t know anything about. But if you don’t notice any input latency that’s all fine, just go ahead and record straight into EZBass.

Stefan Bränberg - Toontrack
Coder

1
Thanked by: cjeich
Replied October 8, 2020 at 14:54 #2629429

cjeich
Participant

Hi. I replied to Toontrack support, but I figured I’d put the answer here for others.

To answer Stefan’s questions, yes – Input Monitoring was enabled on the track, however I use a UAD audio interface and so have been using UAD Console as the front end and monitoring section in Logic. To do this, I turned off ‘Software Monitoring’ which is required for traditional input monitoring to work, Once I enabled it, EZBass was functioning as expected. This is found in Preferences > General.

Thanks to the Toontrack support team for getting back to me so quickly on this one!
Replied March 7, 2021 at 23:45 #2716626
johnhendow
Participant

I am having the same problem as described above. I can see audio in the meters for the plugin, but I can’t get the plugin to show that it’s connected to EZ Bass. Per the thread above, I have tried this with Software Monitoring on / off, and Input Monitoring on / off.

Catalina v10.15.7

Logic v10.6.1

Audio Sender v1.0.4

EZ Bass v1.0.8

Recommendations?

EZbass version: 1.0.8
Operating system: macOS Catalina (10.15)
Author

Replies

Viewing 3 replies - 1 through 3 (of 3 total)

Audio Sender and Logic Pro X

EZbass Help

Viewing 3 replies - 1 through 3 (of 3 total)