[roger m]

Hi Olle, thanks for chiming in.

So if my target is Articulation, then I should bypass the Velocity Ctrl. section?

Also, what exactly am I doing when I bypass it? To put it another way, If I bypassed it and did nothing else, what would be the outcome? I really am trying to understand this stuff.

Thanks,

[roger m]

Hi John, I think sometimes my problem is that I don’t understand much of the lingo used in daw and software. Especially where it applies to MIDI. Here is a paragraph from the manual.

The Velocity transformation of MIDI node members is applied first, before being relayed to the target, a
discrete Articulation, or another MIDI node. If the target is an Articulation, the MIDI information will therefore
pass through two independent sets of Velocity Control units. This may not be desirable, and for this reason the
Velocity Ctrl section belonging to MIDI node members allows you to bypass the target Velocity Ctrl section.

Given what I’m trying to do, do I want to bypass the Velocity Ctrl. section?

What is the difference between an Articulation and a MIDI node? Which one am I trying to change?

Is the “Target” the end result of what I’m tying to do?

Someone needs to come up with a glossary of terms.

[roger m]

Thanks John. I’ll check that out.

[roger m]

Thanks John. I’ll check that out.

[Author]

Replies